Pan/Tilt Configuration; Camera Mounting; Introduction; Installation - FLIR Navigator II Installation Manual

PAN/TILT CONFIGURATION

Introduction

Your Navigator II comes with the camera head, a cable that goes from the
camera head to the Joystick Control Unit (JCU) and Monitor, the JCU and the
mounting hardware described below.

Installation

Caution! The Navigator II should be installed by a factory-authorized installer.
Incorrect installation could void your warranty.
It is strongly recommended that you DO NOT separate the Camera from its
base during installation. Doing so will void your warranty.

Camera Mounting

Caution! Mount your Navigator II with the pedestal sealed to a flat, horizontal surface with the
camera above the mounting plane. Any other type of installation is not appropriate, may result
in damage to the camera, and may void the warranty.
Step 1 Using the "Camera Mounting Template" supplied as a part of the Installation Packet
as a guide, drill the mounting holes and 0.50 through-hole for the cable seal. Before drilling
holes, ensure that the template is facing the right direction; mount the camera with the front
of the base facing the intended viewing direction.