Advertisement
Install the pushrod connectors onto the servo arms as shown. Tighten the nuts just to a snug fit – the
connector must be able to rotate after installation. Use medium CA glue on the nut to keep the
connector from falling off due to vibration.
Note: We recommend the use of Dubro high strength long servo arms.
Mount elevator servo as shown, attach the pushrod to the elevator horn with a 2mm screws, washer,
and nut. Use medium CA glue to lock the nut onto the 2mm bolt to keep the screw from coming loose
due to vibration. Tighten the pushrod connector with a 1.5mm hex wrench.
Advertisement
