SCAN DSA 5 Instructions For Installation And Use page 3

4
2
5
Cleaning of the glass
If you need to clean the glass, the door can be opened
in the following way:
IMPORTANT! Close the door and lock it by turning the
locking button (see "Opening of the door") before you
begin.
In order to protect the ceramic gasket at the bottom of the
door, you should place the distance piece (fig. 5) under
the door in the left side. Put a 6 mm hexagon spanner
in the hole of the right side of the door (fig. 6) and turn
clockwise. Swing out the door, clean the glass and close
the door. Turn the screw counter-clockwise and remove
the dis- tance piece.
Accessories
For the free-standing model you can have the following
accessories:
• Front plate at the door (steel or soapstone)
• Cover for the elbow
• Rear or top plate in stainless steel
• Shaped floor plate (steel or glass)
• Connection piece for fresh-air intake
For the built-in insert you can have the following acces-
sories:
• Support frame
• Damper for the regulation of the chimney draught
You should read this manual as well as the General Instructions for Inatallation before beginning the installation.
Scan DSA 5
3
8
fig. 2
Ceramic smoke deflector
7
After the chimney has been swept, you have to remove the soot
that has fallen down onto the ceramic smoke deflector. Lift up the
deflector in one side and tilt it down in the other side so that the soot
6
falls into the combustion chamber. Attention! The smoke deflector is
made of Skamol, which is a delicate material that easily breaks, so
take care when handling it.
fig. 1
fig. 3
fig. 5
fig. 7
fig. 9
2
3
5
7
4
fig. 4
6
fig. 6
fig. 8
fig. 10