iStorage Diskashur2 Quick Start Manual

Thank you for purchasing the iStorage diskAshur
default Admin PIN of 11223344 and although it can be used straight out of the box with the default Admin PIN,
security reasons, we highly that a new Admin PIN be created immediately
heading 'Changing the Admin PIN'.
Desk Lock
Slot Connection
LED LIGHTS
- Standby State/Locked
- User Mode/Unlocked
- Admin Mode
LOCK
SHIFT
UNLOCK

First Time Use

Your diskAshur undergoes a rapid self-test to verify all security components are working properly each time you
2
plug into a powered USB port. The LEDs will go through 3 test stages, blinking in sequence RED,
BLUE, followed by two GREEN
force the diskAshur to securely reset itself and automatically resume the self-test without affecting the security
2
characteristics or any data stored on the drive.
To unlock the diskAshur for the first time with the default Admin PIN, insert the integrated USB 3.1 cable to a
2
powered USB port and follow the instructions in the table below.
1. In Standby State (solid RED
Admin PIN '11223344' and then press the 'UNLOCK'
button
Note: Once the diskAshur
a solid state. It can be locked down immediately by pressing the 'LOCK' button once or by
(strongly recommended) clicking the 'Safely Remove Hardware/Eject' icon within your operating system.
PIN Requirement
• PINs must be a minimum length of 7 and maximum 15 digits.
• Cannot contain all sequenital numbers (2345678 or 9876543).
• Cannot contain all repeating numbers (1111111).
• The SHIFT key can be used for additional combinations (e.g. SHIFT+1 is a
separate value to just 1).
All manuals and user guides at all-guides.com
. Your diskAshur
2
blinks and then to RED (Standby State) on a successful test. Any test failure will
LED), enter the default
has been successfully unlocked, the
2
QUICK START GUIDE
is preformatted in NTFS and shipped with a
2
by following the instructions under the
GREEN and BLUE LEDs will alternately blink
several times and then to a solid
changing to a blinking GREEN
a solid GREEN LED
GREEN LED will remain on and in
for
Alphanumeric
Keypad
Integrated
USB 3.1 Cable
GREEN and
BLUE LED
and finally to