Diskashur Pro Ssd Layout; First Time Use - iStorage diskashur PRO SSD User Manual

3. diskAshur PRO SSD Layout

®
PRO

4. First Time Use

Before diskAshur PRO SSD can be used, the Admin PIN MUST be set. The LED will display Solid
indicate diskAshur PRO SSD is waiting for a PIN to be set.
To Set-up the Admin PIN:
UNLOCK
1. Press
2. Enter the new Admin PIN and press
will flash for 3 short blinks, then return to Solid
3. Re-enter the Admin PIN and press the
LED will be Solid for 3 seconds.
4. LED will then turn
LOCK key is pressed, will return the drive to a standby state.
5. The Admin PIN is now set and will allow access to the drive or the Admin features.
6. To UNLOCK
new PIN and press UNLOCK.
Requirements for Admin, User and Self-Destruct PIN:
PINs must be a minimum length of 7 maximum 16 digits.
Cannot contain all consecutive numbers (2345678 or 9876543)
Cannot contain all same number (1111111)
The SHIFT key can be used for additional combinations.
SHIFT + 1 are a separate value than just 1.
1
TM
2
3
4
4
LED Indicator lights
3
When you first plug in the FIPS diskAshur PRO SSD, the unit will
do a self-test to verify all security components are working properly.
2
The LEDs will go through 3 test stages RED, GREEN, and BLUE.
This will be followed by three
1
Any test failure will leave the unit in an interoperable state with the
RED
+ 9. The LED will change to Solid
UNLOCK
UNLOCK
BLUE and remain in Admin mode for 30 seconds or if the
the drive, exit Admin by pressing the
www.istorage-uk.com
SHIFT button
UNLOCK button
LOCK button
GREEN
LED flashing.
BLUE and Blinking GREEN.
GREEN
key. If accepted the
BLUE and Blinking GREEN.
key. If accepted the
LOCK button. Then enter the
flashes on a successful test.
BLUE and Solid
LED
GREEN
GREEN to
#7