First Time Use
Before the drive can be used, the Admin PIN MUST be set.
The LED will display solid
set.
To Set-up the Admin PIN:
Press UNLOCK + 9. The LED will change to solid
1.
Enter the new Admin PIN and press UNLOCK key. If accepted the
2.
short blinks, then return to solid
Re-enter the Admin PIN and press the UNLOCK key. If accepted the
3.
for 3 seconds.
BLUE
4.
LED will then turn
pressed, will return the drive to a standby state.
The Admin PIN is now set and will allow access to the drive or the Admin features.
5.
To UNLOCK the drive, exit Admin by pressing the LOCK button. Then enter the new PIN and
6.
press UNLOCK.
*Note:
PINs must be a minimum length of 7 and maximum 16 digits.
Cannot contain all sequenital numbers (2345678 or 9876543)
Cannot contain all repeating numbers (1111111)
The SHIFT key can be used for additional combinations
(e.g. SHIFT+1 is a separate value than just 1)
®
BLUE
GREEN
and solid
to indicate the diskAshur PRO
BLUE
and blinking GREEN.
and remain in Admin mode for 30 seconds or if the LOCK key is
QUICK START GUIDE
1
2
4
3
3
4
2
1
When you first plug in the diskAshur PRO
unit will do a self-test to verify all security
components are working properly.
The LEDs will go through 3 test stages RED,
GREEN, and BLUE. This will be followed by
GREEN
three
flashes on a successful test.
Any test failure will leave the diskAshur PRO
an inoperable state with the
BLUE
and Blinking GREEN.
GREEN
GREEN
SHIFT button
UNLOCK button
LOCK button
LED Indicator lights
RED
LED flashing.
®
is waiting for a PIN to be
LED will flash for 3
LED will be solid
®
, the
®
in