Introduction; Unpacking And Components - Accu-Scope 3012-LED Manual

Microscope series

Table of Contents

3012-LED MICROSCOPE SERIES

INTRODUCTION

Congratulations on the purchase of your new ACCU-SCOPE

microscope. ACCU-SCOPE

microscopes are engineered and manufactured to the highest quality standards. Your microscope will

last a lifetime if used and maintained properly. ACCU-SCOPE

microscopes are carefully assembled,

inspected and tested by our staff of trained technicians in our New York facility. Careful quality control

procedures ensure each microscope is of the highest quality prior to shipment.

Your microscope arrived packed in a molded shipping carton. Do not discard the carton: the carton

should be retained for reshipment of your microscope if needed. Avoid placing the microscope in dusty

surroundings or in high temperature or humid areas as mold and mildew will form. Carefully remove the

microscope from the Styrofoam container by its arm and base and place the microscope on a flat,

vibration-free surface. Check the components against the following standard configuration list:

1. Stand, which includes the supporting arm, focusing mechanism, mechanical stage, slide holder,

nosepiece, N.A. 1.25 Abbe condenser with iris diaphragm and illumination system.

2. Viewing head (binocular or trinocular depending upon the model ordered)

3. Eyepieces as ordered

4. Objectives as ordered

5. Immersion oil

6. Dust cover

7. 3-prong electric power cord

Optional accessories such as optional objectives and/or eyepieces, slides sets, etc., are not shipped as

part of the standard equipment. These items, if ordered, are shipped separately.

ACCU-SCOPE

73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com

Table of Contents