Page 5
3025 SERIES PHASE CONTRAST SET-UP INSTRUCTIONS 1. Place the microscope in front of you and plug in your light source. 2. Mount the objectives clockwise (lowest magnification to highest magnification) onto the microscope nosepiece. 3. Install the turret phase condenser (Fig. 2) into the condenser holder located under the stage and tighten into place.
TROUBLESHOOTING GUIDE PHASE CONTRAST MICROSCOPY PROBLEM CAUSE CORRECTIVE MEASURE The condenser phase annular Adjust the phase annular diaphragm image and the objective diaphragm so that it matches with phase plate do not match. the objective phase plate. Insert the phase annular The condenser phase annular diaphragm with the same phase diaphragm and the objective phase...