Operation; Binocular Or Trinocular Viewing Head - Accu-Scope 3012-LED Manual

3012-LED MICROSCOPE SERIES
ASSEMBLY
(continued)
Filter
If desired, a blue filter may be installed onto the bottom of the condenser. NOTE: When installing the
filter, hold it from the edges as you do not want to leave fingerprints on the filter. Remove the filter holder
from the bottom of the condenser and insert the filter into the filter holder Insert the filter holder back into
the bottom of the condenser.
Voltage Check
Confirm that the input voltage indicated on the rear label of the microscope corresponds to your line
voltage. The use of a different input voltage than indicated will cause severe damage to your
microscope.

OPERATION

Plug the 3-prong line cord into the microscope and then into a grounded 120V or 220V A.C. electrical
outlet. Usage of a surge suppressor outlet is highly recommended. Turn the illuminator switch to "―."
For longer bulb life always turn the illuminator variable intensity knob to the lowest illumination intensity
setting possible before turning the power on or off.

Binocular or Trinocular Viewing Head

To adjust the interpupillary distance, hold the left and right eyetubes while observing a specimen. Rotate
the eyetubes around the central axis until the fields of view of both eyetubes coincide completely. A
complete circle should be seen in the viewing field when viewing the specimen slide. An improper
adjustment will cause operator fatigue and will disrupt the objective parfocality.
®
ACCU-SCOPE 73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
9