Related Manuals for Accu-Scope 3000-LED
Summary of Contents for Accu-Scope 3000-LED
- Page 1 INSTRUCTIONS 3000-LED SLIDER PHASE CONTRAST MICROSCOPY INSTRUCTIONS PHASE ANNULI ARE PRE-CENTERED 73 Mall Drive, Commack, NY 11725 • 631-864-1000 (P) • 631-543-8900 (F) www.accu-scope.com • info@accu-scope.com...
- Page 3 3000-LED SLIDER PHASE CONTRAST INSTRUCTIONS Slider Phase Contrast Installation & Use Instructions Objectives Phase contrast should be used for observing unstained specimens (i.e. Green Filter cultured cells) at high contrast. Prior to shipment your phase contrast set was assembled, tested and inspected at our distribution center in New York.
- Page 4 3000-LED SLIDER PHASE CONTRAST INSTRUCTIONS REMOVING THE DUST SHIELD COVER Slide the dust shield cover out from the condenser housing (FIG. 1). Be sure to keep it to reinstall it should you need to transport the microscope. FIG. 2 shows the condenser housing with the dust shield cover removed.
- Page 5 3000-LED SLIDER PHASE CONTRAST INSTRUCTIONS PHASE CONTRAST IMAGE FORMATION MICROSCOPE BY PHASE CONTRAST The normal microscopic object is seen An annular aperture in the diaphragm placed in the focal because it has regions of varying density. In plane of the substage condenser controls the illumination normal brightfield illumination a completely of the specimen.
-
Page 6: Troubleshooting Guide
TROUBLESHOOTING GUIDE PHASE CONTRAST MICROSCOPY PROBLEM CAUSE CORRECTIVE MEASURE The condenser phase annulus image Adjust the phase annulus so that it is and the objective phase plate are not aligned with the objective phase aligned plate. Rotate the phase annulus selector The condenser phase annulus and the wheel to the position that matches the Poor phase...