Attaching Printer To Remote Control Unit With Twinax Interface; Attaching Printer To An Ibm System/36 With Twinax Interface - IBM 6400 Setup Manual

Attaching Printer to Remote Control Unit with Twinax Interface

AS/400's auto configuration program does not support remote attached
printers. You must manually configure this printer as a remote printer
attached to a 5294, 5394, or 5494 Remote Control Unit. Use the following
parameters when configuring this printer as a remote printer on AS/400:
Parameter Description
Device description
Device class
Device type
Device type
Device model
Advanced Function
Location Address
Online at IPL
Attached controller
Font identifier
Form feed
NOTE: AFP *Yes can be specified if the level of OS/400 supports the

Attaching Printer to an IBM System/36 with Twinax Interface

DANGER:
<4> Do not connect or disconnect any communication port, teleport,
attachment connector, or power cord during an electrical storm.
<5> Power off the print and disconnect the power cord before connecting or
disconnecting communication port, teleport, or attachment cable
connector.
This section contains instructions for attaching your printer to an IBM
System/36. For additional information not found here, see your System/36
documentation.
To connect your printer to a System/36, follow these steps:
Parameter
DEVD
DEVCLS
TYPE
TYPE
MODEL
AFP
LOCADR
ONLINE
CTL
FONT
FORMFEED
printer as an AFP printer and PSF/400 is installed.
Appendix D. Attaching Host Systems to a Coax/Twinax Printer
Parameter Setting
Workstation printer name
*RMT
*IPDS (When printer is set to 4234–12 mode.)
4234 (When printer is set to 4234–2 mode.)
0000 (00 if IPDS (4234–12) and 02 if SCS (4234–2))
*NO (See Note)
xx
*YES
Remote controller name
yyy (Default font identifier)
* Cont
D–5