Character Sets - IBM 6400 Setup Manual

Character Sets

This parameter selects a character set for the P–Series emulation. Once you
have selected a character set, you must also define a print language for that
character set, described under the PRINT LANGUAGE option.
IBM PC (the default)
MULTINATIONAL
ECMA LATIN 1
DEC MULTINATIONAL
OCR A
OCR B
0858 PC EURO MULTILINGUAL
0923 LATIN 9 8859–15
NOTE: See the 6400 ASCII Programmer's Reference Manual for information on

character sets.

Print Language
If you selected one of the character sets other than OCR A/OCR B, 0858, or
0923 (which have only one available print language), you must also select a
print language for that character set. The print languages available for each
character set are shown in Figure 4–18 on page 4–68. The default print
language for each character set follows:
IBM PC:
MULTINATIONAL:
ECMA LATIN 1:
DEC MULTINATIONAL: Default is ASCII (USA).
Default for Select Subset Primary is
ASCII (USA).
Default for Select Subset Extended is
0437 PC Character Set.
Default is ASCII (USA).
Default for Select Subset Primary is
ASCII (USA).
Default for Select Subset Extended is
MULTINATIONAL.
Chapter 4. Configuration Menus 4–69