Waste Ink Tray Assy - Epson Stylus Photo RX 560 Service Manual

EPSON Stylus PHOTO RX560/580/590

4.2.6 Waste Ink Tray Assy

C A U T I O N
When removing the Waste Ink Tray Assy, take due care not to
stain any surrounding objects with waste ink.
1. Remove the Panel Assy (p.42)
2. Remove the Scanner Unit (p.44)
3. Remove the Middle Housing (p.48)
4. Remove the Waste Ink Tube from the Waste Ink Tray Assy. (Fig. 4-28)
When connecting the Waste Ink Tube, wipe the ink, if any, off
the joint area of the tube. With ink left adhering to the joint
area, the tube cannot be connected firmly and thus may easily
come off.
In addition, the tube, which is to be routed with the red line
always facing up, must be connected with care that the tube is
free from distortion.
Route the Waste Ink Tube with the red line always facing up so
that the tube is free from distortion. And with the tube passed
through the hook as shown in the figure, install the Waste Ink
Tray Assy. (Fig. 4-29)
A D J U S T M E N T
On the occasion of replacing a part with a new one, replace all the
R E Q U I R E D
specified parts with new ones and clear the counter value after
assembly.
5.1.1 Adjustment by Use of Adjustment Program (p.74)
Disassembly and Assembly
Figure 4-28. Removing the Waste Ink Tray Assy
Always with red line facing up
Pass the tube
through this hook
Figure 4-29. Notes on Installation of the Waste Ink Tray Assy
Removal of Exterior Parts
Waste Ink Tray Assy
Waste Ink Tube (to the I/S Assy)
Route here
Revision A
NG
Do not pass the tube
through this hook
51