Epson Stylus Photo RX 560 Service Manual page 47

EPSON Stylus PHOTO RX560/580/590
4. Place the ferrite cores of group A as shown, and connect the connectors to the
Main Board. (Fig. 4-17)
5. Fasten the ferrite cores with tape. (Fig. 4-18)
Route the harnesses of group B in the order of the power supply harness (CN3) →
6.
PF Encoder (CN8) → CD-R Sensor (CN4), and connect them to the circuit board.
(Fig. 4-18)
7. Connect the FFCs of group C to the connectors. (Fig. 4-19)
8. Stick acetate tape on the USB terminal (in the front). (Fig. 4-19)
The harness for the Scanner CR Motor (CN17) and that for the
PF Motor (CN13) are provided with the same 2-pin white
connector. Take care not to confuse them when connecting the
connectors to the Main Board.
Stick the acetate tape on the USB terminal (in the front) to
cover both the USB connector and Middle Housing.
Routing the harness of group A
Route here
Route here
Figure 4-17. Routing the Harness and Setting the Ferrite Cores
Disassembly and Assembly
CN14 CN13
CN6
CN7
Ferrite Core x4
Removal of Exterior Parts
Routing the harness of group B
Route the harness of CN4
CN3 route
as shown so that it holds
down the harness of CN3.
Harness treatment of CN8 (FFC)
Double-stick tape x2
Acetate Tape (18x60mm) x2
Figure 4-18. Routing the Harness of Group B
Routing the harness of group C
Connect with
attention paid to the
terminal surface.
Figure 4-19. Connection of Group C (FFCs)
Revision A
CN8
CN4 CN3
FFC x5
Acetate Tape (18x20mm)
47