Epson Stylus Photo RX 560 Service Manual page 78

EPSON Stylus PHOTO RX560/580/590
Adjustment flow
Make the adjustment according to the following adjustment flow:
START
Printing the BRS
adjustment pattern (p.79)
Reading the BRS
adjustment pattern (p.80)
Yes
Has error occurred?
No
Printing the PFP
adjustment pattern (p.81)
Reading the PFP
adjustment pattern (p.82)
Yes
Has error occurred?
No
Printing the PFP
confirmation patterns (p.83)
NG
Confirmation pattern
judgment
OK
END
Figure 5-6. BRS/PFP Adjustment Flow
Adjustment Banding Reduction System (BRS) Adjustment / Paper Feed Profile Correction (PFP)
C H E C K
If an error has been displayed on the adjustment program,
P O I N T
confirm the following points and perform the adjustment again.
If an error occurs even after confirmation of the following points,
the error is attributable to any problem with the scanner.
Therefore, perform the adjustment again using another scanner.
1. Make sure that the printer for which the correction value is
registered is the same one that was used to print the
adjustment pattern.
2. Make sure that the printed pattern is located on the document
table properly along the scale.
3. Make sure that there is no clearance between the reference
scale and the printed pattern.
4. Make sure that the scanner glass surface and the reference
scale are free from dust and dirt.
Revision A
78