Removing The Waste Ink Pads - Epson STYLUS Scan 2500 Service Manual

EPSON Stylus Scan 2500

4.5.1 Removing the waste ink pads

1. Remove the rear cover and top cover as described in "Removing the
Housing" on pag e82.
2. Remove the scanner support frame as described in "Removal of the
Circuit Board Tray" on page 90.
3. Remove one screw (CBP 3x8) that secures the waste ink tank and is
located on the right side of the printer mechanism.
Spacer
Figure 4-1. Removing the waste ink tank
Disassembly & Assembly
4. Remove the spacer on the left side of the tray and carefully pull the tray
5. Remove one screw (CBP 3x10) securing the waste ink tank cover, and
(CBP 3x8)
6. Carefully remove the old waste ink pads so as not to get yourself or
Waste ink tank
Removal of the Printer Consumables
out and downward.
When re-installing the waste ink tank, make sure to
secure the hooks on the left of the tray on top of the
spacer.
then remove the cover.
anyone/anything else dirty.
Revision A
92