Kohler Command PRO CS Service Manual page 97

Remove Carburetor
WARNING:
Gasoline may be present in the carburetor and fuel
system. Gasoline is extremely flammable, and its vapors
can explode if ignited. Keep sparks, open flames and other
sources of ignition away from the engine.
1. Remove the air cleaner base gasket from the two
mounting studs.
2. Pull the carburetor outward and off the
mounting studs.
3. Remove the outer gasket, spacer block, and inner
gasket from the studs.
Figure 9-16. Removing Carburetor, Gaskets, and
Spacer.
*If you want to remove the carburetor without
disturbing the governor lever mounting,
proceed as follows.
1. Gently hold the governor lever in the full throttle
(left/clockwise) position.
2. Pull the carburetor outward and off the mounting
studs. Tilt the carburetor and disconnect the
throttle link and dampening spring from the
throttle lever. See Figure 9-17.
Figure 9-17. Removing Carburetor Without
Governor Lever Removal.
Remove Retractable Starter
1. Remove the hex flange screws securing the
retractable starter to the blower housing. See
Figure 9-18.
Figure 9-18. Removing Starter Mounting Screws.
Section 9
Disassembly
9
9.5