I Function Display - Icom iC-M505 Instruction Manual

2
PANEL DESCRIPTION

I Function display

q w e r t
!4 BUSY 25W
RX
!3
SCRAM
!2
NORMAL SCAN
-34°34.506N
!1
123°23.236W
!0 Local
q RX SPEAKER INDICATOR (p. 51)
Appears during the RX Speaker mode.
w POWER INDICATOR (p. 8)
➥ "2 2 5 5 W W " appears when high power is selected.
➥ "1 1 W W " appears when low power is selected.
e TAG CHANNEL INDICATOR (p. 13)
Appears when a TAG channel is selected.
r DUPLEX INDICATOR (p. 7)
Appears when a duplex channel is selected.
t CHANNEL GROUP INDICATOR (p. 7)
Indicates whether an International "I I N N T T ," U.S.A. "U U S S A A ,"
DSC "D D S S C C " or ATIS "A A T T I I S S " channel is in use. (Depends
on version)
4
y
INT CALL
DUP
TAG
1:10 CALLING
y CALL CHANNEL INDICATOR (pgs. 6, 9)
Appears when the call channel is selected.
u LOW BATTERY INDICATOR
Blinks when the battery voltage drops to approx. 10 V DC
u
or below.
i CHANNEL NUMBER READOUT
i
Indicates the selected operating channel number.
o CHANNEL COMMENT INDICATOR
Channel comment appears if programmed. (p. 10)
!0 TIME ZONE INDICATOR
o
➥ Shows the current time data when a GPS receiver is
connected.
• "? ? ? ? " may blink every 2 sec. instead of current time data when
the GPS current time data is invalid.
• "? ? ? ? " may blink every 2 sec. instead of current time data 4
hours after the time data is input manually, up until 23.5 hours
have past.
➥ "L L o o c c a a l l " appears when the offset time data is set.
(p. 47)
➥ "N N o o T T i i m m e e " appears when no GPS receiver is con-
nected and no time data is input manually.