Replacing The Processor - Fujitsu PRIMERGY TX300 S3 Options Manual

Replacing the processor

6.2 Replacing the processor
V
CAUTION!
Only processors of the same type may be used on the system board. The
second processor must have at least the same clock frequency as the
first processor. The server always configures itself to the lower clock
frequency of the two processors. For dual operation, use a suitable multi-
processor operating system.
Ê Open the server as described in the
Ê Remove the ventilation duct over the main memory (see
Ê Remove the ventilation duct over the system fans (see
Ê Remove the heat sink holder (see
Ê Remove the processor fan holder (see
Figure 27: Removing the heat sink
Ê Loosen the four screws in a crossover pattern.
40
chapter "Preparation" on page
page 32).
page 34).
Options Guide
Processors
17ff.
page 27).
page 32).
TX300 S3