Installing A Localview Module - Fujitsu PRIMERGY TX300 S3 Options Manual

Accessible drives
Figure 48: Cable system board
Ê Connect the cable to the system board. Take care to the isolated cable side:
insert the cable with the isolated cable side in direction to the lock bar.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
8.4

Installing a LocalView module

In the TX300 S3, the LocalView module can be installed in the FDD-DVD-
LocalView box or in the SAS/SATA HDD extension box. In the SAS/SATA HDD
extension box this bay can be equipped with a LocalView module or a slimline
floppy disk drive.
The LocalView module is an optional extra for the servers of the PRIMERGY
series. On the display panel of the LocalView module you can read status
messages directly on the server. These status messages provide information on
the system and notify you of hardware faults (e.g. fan failure, CPU over voltage,
etc.).
The LocalView module can be pulled out like a sliding drawer. You can also
angle the LocalView display panel downward.
TX300 S3
Installing a LocalView module
79ff.
Options Guide 59