Fujitsu PRIMERGY TX300 S3 Options Manual page 48

Installing an accessible 5.25-inch drive
Figure 33: Removing the dummy cover
Ê Press the two metal tongues of the EasyClick rails inward (1) until the locking
mechanism is released.
Ê Remove the dummy cover from the bay (2).
Figure 34: UNC and M3 screws
Ê Remove the EasyClick rails from the dummy cover by removing the four
screws on each side.
I
Note that there are two M3 screws and two UNC screws on each side.
V
CAUTION!
Keep the dummy cover for future use. If you remove the accessible drive
again and do not replace it with a new one, the dummy cover must be
reinstalled to comply with EMC regulations and to satisfy cooling require-
ments and fire protection measures.
48
UNC screw
(large screw head)
Options Guide
1
2
1
M3 screw
(small screw head)
Accessible drives
TX300 S3