Fujitsu PRIMERGY TX300 S3 Options Manual page 69

Controller in non-hot-plug PCI slots
1
2
Figure 60: Installing a controller
Ê Install the controller in the PCI slot and press it carefully into the associated
plug-in location on the system board (1). Ensure that the rear cover fits into
the recess (a).
Ê Push the green fastening slider over the rear cover's bracket (2).
Ê If required, connect the cables to the controller and other components.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
TX300 S3
a
79ff.
Options Guide
Installing a controller
69