Fujitsu PRIMERGY TX300 S3 Options Manual page 28

Extending/replacing the main memory
1
Figure 13: Removing a memory module
Ê Press the holders on either side of the mounting location concerned outward
(1).
Ê If the mounting location was already equipped: pull the memory module out
of the mounting location (2).
2
Figure 14: Inserting a memory module
Ê Press the holders on either side of the mounting location concerned
outward.
Ê Insert the memory module in the mounting location (1) until the holders at
the sides engage (2).
28
2
1
Options Guide
Main memory
1
2
TX300 S3