Table of Contents
Advertisement
Accessible drives
V
CAUTION!
Keep the
page
47dummy cover for future use. If you remove the LocalView
module again and do not replace it with a new one, the dummy cover
must be reinstalled to comply with EMC regulations and to satisfy
cooling requirements and fire protection measures.
Ê Slide the LocalView module into the mounting location until it latches in
place.
Ê Attach the Con3 connector of the I
connector on the rear of the LocalView module.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter "Completion" on page
I
Further information on operation and display modes is provided in the
documentation for the LocalView module.
8.5
Installing the FDD-DVD-LocalView box
In the third, lowest 5.25-inch bay a multibay (FDD-DVD-LocalView box) can be
installed.
Ê Open the server and remove the front cover or rack front cover as described
in the in the
chapter "Preparation" on page
Ê If a drive has been installed in the lowest 5.25-inch bay, remove the drive and
install it in a free 5.25-inch bay (see
inch drive" on page
TX300 S3
section "Installing an accessible 5.25-inch drive" on
47).
Options Guide
Installing the FDD-DVD-LocalView box
2
C cable (T26139-Y3718-V601) to the
79ff.
17ff.
section "Installing an accessible 5.25-
61
Advertisement
Table of Contents
