Fujitsu PRIMERGY TX300 S3 Options Manual page 37

Processors
1
3
Figure 23: Installing the heat sink
Ê Place the heat sink on the processor socket.
V
CAUTION!
If you find an air flow arrow on the top side of the heat sink, place the heat
sink in the way that the air flow arrow shows in direction of the server's
rear side.
Ê Fasten the heat sink by tightening the four screws in a crossover pattern (first
left side rear (1), then right side front (2) etc.).
V
CAUTION!
Never install a processor without a heat sink and processor fan as
otherwise the processor may overheat, causing the processor and
system board to fail.
TX300 S3
Installing a second processor
4
2
Options Guide 37