Fujitsu PRIMERGY TX300 S3 Options Manual page 72

Installing a parallel interface
Figure 62: Fastening the plug connector at the rear of the housing
Ê Feed the plug connector through the notch at the rear of the housing.
Ê Fasten the plug connector to the rear of the housing using the threaded bolts
supplied (see arrows).
Figure 63: Routing the cable
Ê Route the cable as shown in the photo.
Ê Connect the cable's connector to the parallel port connector on the system
board (see arrow).
72 Options Guide
Parallel interface for printers
TX300 S3