Receiver; Front Panel; Rear Panel - SMART Joy S2 User Manual

Product Description
2.2

Receiver

2.2.1

Front Panel

No. Description
1 Standby LED, lights red if the receiver is in Standby mode.
2 Signal-LED, lights green after the installation of programs is completed and a video signal is
routed to the TV set..

2.2.2

Rear Panel

No. Marking
1 LNB IN
2 SERVICE
3 175 - 250 V ~, 50/60 Hz
4 TV
DIGITAL AUDIO
5
6
The green LED (light emitting diode) on the receiver front panel does not light
immediately after connecting the device to the power supply, but only after the
installation of programs is completed (either via RAPS or via program scan).
If you plug the power cord for the first time, the LED lights up only after instal-
lation. During later operation the receiver's program list already exists; it takes
just a few seconds from inserting the power plug until you see the green LED.
Description
Connection for LNB (DVB-S)
Serial interface (RS232)
Grid connection
SCART connection for TV device
Digital RCA audio out (SPDIF)