Delete All; Motor Setting; Antennen Limit; Single Satellite Search - SMART Joy S2 User Manual

6.1.3.5

Delete All

Select the menu item Delete All to delete all previously set satellite positions. This menu

item is only active, if you selected the motor control DiSEqC1.2
6.1.3.6

Motor Setting

 Select Motor Setting and press OK to open the submenu Motor Setting
1. Select Satellite to select the satellite to which the following settings should apply.
2. Select Transponder to select the transponder that should be decisive for the antenna position
(usually the transponder that is used to send your preferred channel).
3. Select Pos No. & Save to determine a position number at which the respective satellite (i.e. the
respective antenna position) should be saved.
4. Select Go to X to call a position from which you want to make the selection (the value Reference
is the zero position).
5. Select Save and turn the antenna to the west or east by using the keys
for maximum values of signal strength and signal quality (are displayed at the lower screen edge).
6. Then press OK to save the found position. A query will be displayed.
7. Confirm change of position by pressing Yes or discard such change by pressing No.
8. Repeat the steps 1 to 6 for any further satellites/transponders, if applicable.
 Select Recalculation and press OK to discard any previous settings and to again determine
antenna position.
 Press EXIT to return to the submenu Antenna Setup.
6.1.3.7

Antennen Limit

 Select Limit setup and press OK to open the window Limit setup.
1. Select Limit setup to switch between Disable Limit, West Limit and East Limit.
2. Mark the button Limit setup and move the limit - as defined in the previous step - to the east or
west by using the keys V+ / V-.
3. Mark the button Go to Reference and then press OK to move the motor antenna to its starting
position.
4. Press EXIT to return to the submenu Antenna Setup.
6.1.4

Single Satellite Search

Here you can scan individual satellites for receivable channels.
At Satellite, select the satellite for which the scan should be performed.


Select FTA Only

channels.
At Scan Channel, select if you want to perform scan only for TV channels, only for radio

channels or for TV + radio channels.
6
FTA = Free To Air = unencrypted channels
Also here, options are limited to the satellites that are marked in the Satellite
List as such satellites from which you want to receive channels.
6
to determine if scan should be made only for FTA channels or for all
Extended Settings and Functions
and . Search
21