Table of Contents
Advertisement
Press the keys PR-, PR+, V- or V+ to move the cutout.
Repeated pressing of the green ZOOM key enlarges the image more and more (up to 16-fold
magnification).
To leave the ZOOM menu, press EXIT.
6.14
Satellite Overview
Press the SAT key to get a list of all programmed satellites.
6.15
Switching TV/AV
Press the TV/AV key to switch between satellite signal via the receiver and direct antenna signal
via the TV set (switching on/off the 12 V switching voltage at the SCART output).
6.16
Pause Function
To freeze the image of the program currently shown, press the PAUSE key.
To cancel the Pause function, press the PAUSE key again.
6.17
Software Version
The menu item Information in the menu Tools displays the version of the loaded software.
No settings are possible here.
6.18
Factory Settings
If you erroneously saved wrong settings or if you want to pass on the receiver without your settings,
then you can reset the receiver to the factory settings (reset):
To reset the receiver:
1. In the menu Tools, select the sub-menu Factory Settings.
2. Press the OK key. You will be asked if you want to reset the receiver and delete individual set-
tings.
3. Select Yes or No and then press OK. After resetting your receiver, the language selection menu
will be displayed.
6.19
Configuring the RAPS System
6.19.1
Show the Date of the RAPS File on the Receiver
The window RAPS System displays on top at Last changes from the date of the RAPS file on the
receiver. No settings are possible here.
6.19.2
Setting RAPS Mode
Select RAPS Mode to configure RAPS:
Update
The receiver channel list will only be updated.
The receiver will be set to factory defaults. The channel list will be created com-
Config
pletely new (similar to the first installation).
Here you can set the RAPS transponder manually.
Attention!
Setup
Change the RAPS transponder only after regarding advice. If you change it apart
from that, RAPS cannot work correctly anymore.
Extended Settings and Functions
27
Advertisement
Table of Contents
