Table of Contents
Advertisement
Extended Settings and Functions
6.7.2
OSD Timeout
In the sub-menu OSD Setting move the highlight on OSD Timeout and press the keys V+ / V- to
set the number of seconds after which the OSD should be hidden. You may set values from 1 to
10 seconds. Default value is 4s (factory setting).
6.7.3
OSD Transparency
In the sub-menu OSD Setting move the highlight on OSD Transparency and press the keys V+ /
V- to select among Off (0% - no transparency), 10%, 20%, 30%, 40% (almost transparent). The
default option is Off.
6.8
LNB supply voltage
1. Select in the menu System Setup the submenu Other and press OK.
2. Select LNB Power, to switch on /off the LNB supply voltage at LNB IN.
6.9
Channel Play Type
1. Select in the menu System Setup the submenu Other and press OK.
2. Select Channel Play Type, to set whether all channels, only free-to-air channels or only encoded
channels will be displayed.
6.10
Channel Change
When switching between different channels, it often happens that a short pause occurs until the re-
ceiver shows the picture of the selected channel
1. Select in the menu System Setup the submenu Other and press OK.
2. Select Channel Change, to set whether you want the picture to be frozen for a short instant or
prefer a black screen during this time.
6.11
Beeper
1. Select in the menu System Setup the submenu Other and press OK.
2. Select Beeper, to set whether you want your TV set to play an acoustic signal while you're in the
"Antenna Settings" menu.
The acoustic signal sequence accelerates when the signal is better and slows down when the signal
is poorer.
6.12
Automatic Standby Function
1. Select in the menu System Setup the submenu Other and press OK.
2. Select Auto Standby to switch on or switch off the automatic standby function (factory setting is
Auto Standby On).
6.13
Zoom Function
Press green ZOOM key, to enlarge the image.
26
Based on current EC regulations, this receiver is equipped with an energy sav-
ing system. After three hours, the receiver will automatically switch to energy
save mode (energy consumption of less than 1 W) unless a function is trig-
gered via remote control during such period (e.g. volume change or switching
of channels). You can deactivate the automatic standby function via the menu.
Advertisement
Table of Contents
