Update By Receiver; Trouble Shooting - SMART MX56 Manual

3. Update by Receiver

1.Set-to-set Software update with TV
1) Please connect Master receiver and Slave receiver with RS232 cable. Please
note that both master receiver and slave receiver must be turned off before the
connection with RS232 cable.
2) Power on Master receiver and enter into Config menu to display
system update, then turn on the slave receiver, after that the software will be
transferred from master receiver to slave receiver after detect. And after finished,
the slave receiver will re-boot itself, and be operation mode.
2. Set-to-set Software update without TV
1) Please connect Master receiver and Slave receiver with RS232 cable .
Please note that both master receiver and slave receiver must be turned off
before the connection with RS232 cable..
2) Please turn on the master receiver by clicking the power switch on the back
cover of the receiver.
3) Software updating begins, and wait till Slave Receiver re-boot itself and be
operation mode.
Master
RS-232 cable configuration
1 2 3
4 5
2.RXD
3.TXD
5.Ground
6 7 8
9
29
Slave
1 2 3
4 5
(Receive Data)
(Transmit Data)
6 7 8
9

Trouble shooting

Possible Causes
No picture but on screen menus appear!
Terrestrial Antenna
system is
incorrectly installed.
Faulty Antenna
Incorrect TP data
High levels of signal loss through
cables
Faulty connection
Remote control not working!
Batteries exhausted
Incorrect function selected
Remote control not pointed at
device
No stereo sound!
Incorrect cable connecting receiver
and TV
Incorrect volume value
Solution
Check all connections and leads,
Replace Antenna
Re-input TP data
Use a signal booster or
replace cables
Repair connection
Check batteries
Press correct function key
Make sure your remote control
is pointing on your device
Check SCART cable
Check volume value
30