Control Panel - ESAB Aristotig 255 LTN 255 Instruction Manual

GB
6.1

Control panel

On the front of the machine there is a control panel for the selection of functions and
setting of parameters. This consists of a display, setting knob, LEDs and push--but-
tons.
By using the push--buttons you can move between the different functions. The se-
lected function is indicated by respective LEDs coming on.
One line at a time is set. The current line is indicated by a red LED. Movement be-
tween lines takes place using the red arrow keys.
Movement within each line takes place using the green arrow keys.
All settings are made using the setting knob. The LEDs to the right of the display
indicate the actual unit (ampere/volt/seconds). On the lines where only a function is
selected, "------" is shown on the display.
Description of the functions:
Line 1
S
Line 2
S
Line 3
S
Line 4
S
Line 5
S
Line 6
S
Line 7
S
Line 1
TIG welding or MMA welding
If MMA welding is chosen, the current is set here and lines 2--5 are
ignored.
Line 2
TIG/HF ignition or TIG/Liftarc ignition
Place the electrode against the
workpiece.
bt19d12e
Press in the torch switch.
- - 20 - -
bt07d002
bt07t001