Optical Drive Connector Cable - HP Pavilion 14 Maintenance And Service Manual

4. Remove the TouchPad button board while carefully lifting the cable from the guides (3) (the cable was
disconnected when removing the top cover).
Reverse this procedure to install the TouchPad button board.

Optical drive connector cable

Before removing the optical drive connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. Memory module (see
c. WLAN module (see
d. Optical drive (see
e. Keyboard (see
f. Top cover (see
Remove the optical drive connector cable:
1. Disconnect the optical drive connector cable (1) from the system board.
2. Release the optical drive connector cable from the clip (2) built into the base enclosure.
50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 25), and then remove the following components:
Service door on page 26)
Memory module on page
WLAN module on page
Optical drive on page 32)
Keyboard on page 34)
Top cover on page 41)
28)
30)