Optical drive connector cable
Description
Cable Kit
Before removing the optical drive connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4.
Remove the following components:
a.
Service door (see
b.
Optical drive
c.
Hard drive
d.
Keyboard (see
e.
Top cover (see
f.
Battery (see
Remove the optical drive connector cable:
1.
Position the computer upright on a flat surface.
2.
Disconnect the optical drive connector cable from the system board (1).
3.
Remove the cable from the clips built into the computer (2).
72
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service door on page
(Optical drive on page
34)
(Hard drive on page
36)
Keyboard on page
45)
Top cover on page
52)
Battery on page
66)
33).
Spare part number
905769-001