Display Panel - HP Pavilion 14 Maintenance And Service Manual

Display panel

NOTE: Use these procedures to replace the bezel and raw display panel with the display assembly
connected to the computer. For procedures to replace the remaining subcomponents that require that you
remove the entire display assembly, see
Description
Display bezel (includes screws)
Display panel (raw), 14 in (35.56 cm), WLED, HD, BrightView flat display panel
IMPORTANT:
and replacement
Before removing the display panel, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Remove the panel:
If it is necessary to replace the display bezel:
1. Remove the plastic screw covers (1) and the two Phillips M2.5×3.0 screws (2) that secure the display
bezel to the display assembly.
2. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Flex the inside edges of the bottom edge (3), the left and right sides (4), and the top edge (5) of
the display bezel until the bezel disengages from the display enclosure.
38 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Make special note of each screw and screw lock size and location during removal
Battery on page
Display assembly subcomponents on page
25).
66.
Spare part number
785285-001
785289-001