Optical Drive Connector Cable - HP ProBook 450 G3 Maintenance And Service Manual

Optical drive connector cable

Before removing the optical drive connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Service doors (see
b. Optical drive
c. Hard drive
d. Keyboard (see
e. Top cover (see
Remove the optical drive connector cable:
1. Disconnect the optical drive connector cable from the system board (1).
2. Rotate the side of the connector upward (2) and then remove the connector from the computer (3).
Reverse this procedure to install the optical drive connector cable.
Battery on page
Service doors on page
(Optical drive on page
(Hard drive on page 39)
Keyboard on page 48)
Top cover on page 53)
34).
35).
37)
Component replacement procedures 69