Dts Wiring System; Accessory Drive Belt Inspection - Mercury 200 User Manual

2. Remove the plastic cover from the fuse holder.
3. Remove fuse puller from fuse holder.
4. Remove suspected blown fuse to determine if the silver colored band is broken.
5. Replace fuse with a new fuse of the same amperage rating.
a - Electronic Control Module and purge
valve "ECM" ‑ 20 amp fuse
b - Ignition coils "IGN. COILS" ‑ 20 amp
fuse
c - Fuel delivery "FUEL" ‑ 20 amp fuse

DTS Wiring System

To avoid the possibility of serious injury or death from loss of boat control, do not splice or probe into
any wire insulation of the DTS system. Splicing or probing will damage the wire insulation allowing
water to enter the wiring. Water intrusion may lead to wiring failure and loss of throttle and shift control.
• Verify the harnesses are not routed near sharp edges, hot surfaces or moving parts.
• Verify that all unused connectors and receptacles are covered with a weather cap.
• Verify that the harnesses are fastened along the routing path.

Accessory Drive Belt Inspection

Inspect the accessory drive belt and have it replaced by an authorized dealer if any of the following
conditions are found.
• Cracks in the back of the belt or in the base of V grooves.
• Excessive wear at the roots of the grooves.
• Rubber portion swollen by oil.
MAINTENANCE
b
a
20 20
20 20
20
e
WARNING
!
69
ob01252
c
20
d
20
d - Spare fuses ‑ 20 amp fuse
e - Injector power and boost valve "INJ.
PWR." ‑ 20 amp fuse
ob01259