Air Filter - Mercury 200 User Manual

Air Filter

The air filter assembly is a serviceable item and can be cleaned with warm soap water if required.
AIR FILTER REMOVAL AND CLEANING
1. Loosen air filter clamp screw.
2. Remove crankcase ventilation hose.
a - Crankcase ventilation hose
b - Fuel System Module (FSM) purge
valve hose
3. Remove air filter assembly and disconnect Fuel System Module (FSM) purge valve hose by
rotating the air filter assembly and pulling on hose.
MAINTENANCE
NOTICE - DTS & Optimax Engines
DO NOT USE DEEP CYCLE BATTERIES!
DTS (Digital Throttle and Shift) applications and
Optimax engines must use a marine starting
battery with 1000 MCA, 800 CCA, or 180 Ah.
rating.
IMPORTANT:
Battery cable size and length is critical. Refer to
engine installation manual for size requirements.
Place decal on or near battery box for future service
reference. 5/16" and 3/8" hex nuts supplied for
wing nut replacement. Metric hex nuts not supplied.
a
d
13.5Nm (120 lbs. in.)
DO NOT
USE WING
NUTS.
37-895387
3664
c - Filter assembly
d - Clamp screw
60
3486
b
c