Mercury 200 User Manual page 70

Filter Draining
1. Slide filter holder up to release from bracket. Hoses and wire harness can remain attached to filter
holder.
2. Tip the filter holder to drain any fluid into an approved container.
Filter Installation
1. Position filter holder onto bracket and secure filter holder in place.
2. Lubricate the sealing ring on the filter with oil.
3. Install the filter and tighten securely by hand.
IMPORTANT: Visually inspect for fuel leakage from the filter while turning the ignition key to the run
position, forcing fuel into the filter.
MAINTENANCE
64
ob01253
ob01263