Mercury 200 User Manual page 50

6. Turn the ignition key to "START" position and release the key. The electronic starting system will
automatically crank the engine for starting. If the engine fails to start, the engine will stop cranking.
Return the key to "START" position and try again. Repeat the procedure for the second engine.
7. The "ACTIVE" light located on the console remote control key pad will become illuminated once
the engine is started and communicating with the remote control.
Warming up engine
Throttle Only/Station Select Button ‑ This feature allows the boat operator to increase engine RPM for
warm‑up, without shifting the engines into gear.
1. Move the control handles into neutral position.
2. Press and hold the throttle only/station select button while moving the control handles ahead to
the forward detent.
3. Hold in the button until the horn sounds twice and the neutral lights starts flashing. The flashing
lights indicates that the throttle only is engaged.
4. Advance the control handles to increase engine RPM. Engine RPM is limited to prevent engine
damage.
5. To disengage, return the control handles back to neutral position.
6. The warm up mode can be re‑activated by turning off and re‑starting the engine.
OPERATION
3485
SYNC
ACTIVE
THROTTLE
ONLY
STATION SELECT
SYNC
ACTIVE
THROTTLE
ONLY
STATION SELECT
44
3424
3425