Table of Contents
Advertisement
7.
Enter the contents of the device certificate.
In the "Certificate Request" box, enter the contents of the device certificate received from the certificate
authority.
8.
Click [OK].
"Installed" appears under "Certificate Status" to show that a device certificate for the machine has
been installed.
9.
Click [Logout].
Enabling SSL
After installing the device certificate in the machine, enable the SSL setting.
This procedure is used for a self-signed certificate or a certificate issued by a certificate authority.
1.
Open a Web browser.
2.
Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3.
Click [Login].
The network administrator can log on.
Enter the login user name and login password.
4.
Click [Configuration], and then click [SSL/TLS] under "Security".
The SSL/TLS page appears.
5.
Click [Enable] for the protocol version used in "SSL/TLS".
6.
Select the encryption communication mode for "Permit SSL/TLS Communication".
7.
Click [OK].
The SSL setting is enabled.
8.
Click [OK].
9.
Click [Logout].
• If you set "Permit SSL/TLS Communication" to [Ciphertext Only], enter "https://(the machine's IP
address or host name)/" to access the machine.
Protection Using Encryption
151
5
Advertisement
Table of Contents
