Removing The Rear Wheel (Xp500); Removing The Rear Wheel (Xp500A); Checking The Rear Wheel; Checking The Rear Wheel Drive Hub - Yamaha 2007 XP500 Service Manual

EAS28760

REMOVING THE REAR WHEEL (XP500)

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
2. Remove:
Brake caliper
G
NOTE:
Do not depress the brake lever when removing
the brake caliper.
EAS28760b

Removing the rear wheel (XP500A)

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
2. Remove:
Rear wheel sensor
G
Rear brake caliper
G
ECA15B1042
CAUTION:
Be sure not to contact the sensor electrode
G
to any metal part when removing the wheel
sensor from the sensor housing.
Do not operate the brake lever and brake
G
pedal when removing the brake caliper.
EAS22090

CHECKING THE REAR WHEEL

1. Check:
Wheel axle
G
Rear wheel
G
Wheel bearings
G
Oil seals
G
Refer to "CHECKING THE FRONT WHEEL"
on page 4-10.
2. Check:
Tire
G
Rear wheel
G
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-29 and "CHECKING THE WHEELS" on
page 3-31.
3. Measure:
Radial wheel runout
G
Lateral wheel runout
G
Refer to "CHECKING THE FRONT WHEEL"
on page 4-10.
EAS15B4567

CHECKING THE REAR WHEEL DRIVE HUB

1. Check:
Rear wheel drive hub "1"
G
Cracks/damage → Replace.
EAS22200
MAINTENANCE OF THE REAR WHEEL
SENSOR AND SENSOR ROTOR
ECA15B1037
CAUTION:
Be sure not to contact the sensor electrode
G
to any metal part when removing the front
wheel sensor from the sensor housing.
Do not operate the brake lever when remov-
G
ing the brake caliper.
Checking the rear wheel sensor and sensor
rotor
Refer to "Checking the front wheel sensor and
sensor rotor".
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
NOTE:
After replacing the tire, wheel or both, the rear
G
wheel static balance should be adjusted.
Adjust the rear wheel static balance with the
G
brake disc and rear wheel drive hub installed.
1. Adjust:
Rear wheel static balance
G
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-12.
EAS22200b

INSTALLING THE REAR WHEEL (XP500A)

1. Install:
Rear wheel
G
4-19
REAR WHEEL