Cleaning The V-Belt Case Air Filter Element; Checking The Throttle Body Joints And Intake Manifolds - Yamaha 2007 XP500 Service Manual

stalled in the air filter case.
Make sure the air filter is installed with its mesh
G
side facing towards the rear of the vehicle.
6. Install:
Front cowling inner panel
G
Windshield
G
Front cowling upper cover
G
Refer to "GENERAL CHASSIS" on page 4-1.
EAS20980
CLEANING THE V-BELT CASE AIR FILTER
ELEMENT
1. Remove:
Left upper side cover mole
G
Left footrest board
G
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
V-belt case cover 2 "1"
G
V-belt case air filter cover "2"
G
1
3. Remove:
V-belt case air filter element (left) "1"
G
V-belt case air filter element (right) "2"
G
1
2
4. Clean:
V-belt case air filter element
G
Blow the compressed air to the outer surface
of the V-belt case air filter element.
2
5. Check:
V-belt case air filter element
G
Damage → Replace.
ECA13440
CAUTION:
Since the V-belt case air filter element is a
dry type, do not let grease or water contact it.
6. Install:
V-belt case air filter element
G
V-belt case air filter cover seal
G
V-belt case air filter cover
G
V-belt case air filter cover screw
G
7. Install:
Left footrest board
G
Left upper side cover mole
G
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21010
CHECKING THE THROTTLE BODY JOINTS
AND INTAKE MANIFOLDS
The following procedure applies to all of the
throttle body joints and intake manifolds.
1. Remove:
Leg shield
G
Refer to "GENERAL CHASSIS" on page 4-1.
3-16
V-belt case air filter cover screw
7 Nm (0.7 m•kg, 5.1 ft•lb)
ENGINE