Yamaha 2007 XP500 Service Manual page 26

engine stop switch is set to "ON".
2. Disconnect the V-belt replacement reset cou-
pler "1" for two to ten seconds.
3. And then, connect the V-belt replacement re-
set coupler, the V-belt replacement indicator
will come on for 1.4 seconds. And the V-belt
replacement indicator will go off.
NOTE:
If the V-belt is replaced before the V-belt re-
placement indicator comes on (i.e. before the
V-belt replacement interval has been reached),
the indicator must be reset after the V-belt re-
placement for the next periodic V-belt replace-
ment to be indicated at the correct time.
Self-diagnosis device
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are defective, the
multi-function display will indicate a two-digit er-
ror code.
If the multi-function display indicates such an er-
ror code, note the code number, and then check
the vehicle. Refer to "FUEL INJECTION SYS-
TEM" on page 8-33, "IMMOBILIZER SYSTEM"
on page 8-57, "ABS (ANTI-LOCK BRAKE SYS-
TEM) (XP500A)" on page 8-65.
ECA11790
CAUTION:
If the multi-function display indicates an er-
ror code, the vehicle should be checked as
soon as possible in order to avoid engine
damage.
Clock mode
To set the clock:
1. Push the "SELECT" button and "RESET" but-
ton together for at least two seconds.
2. When the hour digits start flashing, push the
"RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits will start flashing.
4. Push the "RESET" button to set the minutes.
5. Push the "SELECT" button and then release
it to start the clock.
1-17
FEATURES