Checking The Starter Motor Operation; Checking The Stator Coil - Yamaha 2007 XP500 Service Manual

c. When turn the lean angle sensor to 45°.
d. Measure the lean angle sensor out put volt-
age.
LLLLLLLLLLLLLLLLLLLLLL
EAS15B1011
CHECKING THE STARTER MOTOR
OPERATION
1. Check:
Starter motor operation
G
Does not operate → Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to "TROUBLESHOOTING" on page
8-13.
MMMMMMMMMMMMMMMMMMMMMM
a. Connect the positive battery terminal "1" and
starter motor lead "2" with a jumper lead "3".
EWA13810
WARNING
A wire that is used as a jumper lead must
G
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
This check is likely to produce sparks,
G
therefore, make sure no flammable gas or
fluid is in the vicinity.
ELECTRICAL COMPONENTS
b. Check the starter motor operation.
LLLLLLLLLLLLLLLLLLLLLL
EAS28150

CHECKING THE STATOR COIL

1. Disconnect:
Stator coil coupler
G
(from the wire harness)
2. Check:
Stator coil resistance
G
Out of specification → Replace the stator coil.
Stator coil resistance
0.22–0.26 kΩ at 20 °C (68 °F)
MMMMMMMMMMMMMMMMMMMMMM
a. Connect the pocket tester (Ω × 1) to the stator
coil coupler as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
Positive tester probe
White "1"
Negative tester probe
White "2"
Positive tester probe
White "1"
Negative tester probe
White "3"
Positive tester probe
White "2"
Negative tester probe
White "3"
8-115