Yamaha 2007 XP500 Service Manual page 357

Sensor operation table
Switch the meter display from the regular mode to the diagnostic mode. To switch the display, refer to
"DIAGNOSTIC MONITORING MODE".
Diagnos
tic
monitori
ng code
No.
01 Throttle angle
Fully closed position
G
Fully opened position
G
03 Pressure difference
(atmospheric pressure-intake
air pressure)
05 Intake air temperature
06 Coolant temperature
07 Vehicle speed pulse
08 Lean angle sensor
Upright
G
Overturned
G
09 Fuel system voltage
(battery voltage)
20 Sidestand switch
Stand retracted
G
Stand extended
G
60 EEPROM fault code display
No fault
G
Fault detected
G
Item
(15–16)
(97–102)
Displays the intake air pressure. Turn On the engine stop
Displays the intake air tempera-
Displays the coolant tempera-
0–999
0.4–1.4 V
3.8–4.2 V
Approximately 12.0 V
ON
OFF
00
01 or 02 (Fault detection cylin-
(If both cylinders are defec-
G
tive, the display alternates
every two seconds.)
FUEL INJECTION SYSTEM
Meter display
ture.
ture.
der)
8-42
Checking method
Check with throttle fully
closed.
Check with throttle fully open.
switch, then operate the throt-
tle while pressing the start
switch. (If the display value
changes, the performance is
OK.)
Compare the actually mea-
sured intake air temperature
with the meter display value.
(*2)
Compare the actually mea-
sured coolant temperature
with the meter display value.
Check that the number
changes (integrating) when
the rear wheels are rotated.
Remove the lean angle sen-
sor and incline it more than 65
degrees.
Compare with the actually
measured battery voltage. (If
the battery voltage is lower,
perform recharging.)
Turn ON/OFF the Sidestand
switch.
—