Working Pace Setting Method - Brother S-7300A-333P Instruction Manual

6-7. Working pace setting method

・ The target counter can be used to let you know the state of work progress.
・ The target counter increases by 1 each time the time set as the working pace has elapsed.
However, counting is not carried out during the period from when the power is turned on until sewing starts.
1
Switching to working pace setting mode
2
<Working pace setting mode>
In this mode, you can set the pace at which the target counter increases.
* If the operating status (1) for the target counter is set to OFF, the target counter function will not operate.
It will not be possible to set the working pace at this time either.
(1)
3
(2)
4
<Exiting working pace setting mode>
6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
・ In production counter editing mode, press the
working pace setting mode.
* The target counter cannot be edited. The target counter can be reset to
"0000" only by clearing the production counter.
・ I Press the key (1) to set the operating status to
working pace can be set.
The working pace (2) will be displayed. The working pace can be set to
between 00'01" and 59'59".
・ Press the + key to increase the value, and press the - key to decrease the
value. If the setting is changed to a value which is different to the value
which was set previously, the time display will flash.
If you would like to return the setting to the value which was set previously,
press the Reset key.
・ To confirm the setting and exit, press the OK key.
The working pace will be confirmed and the mode will return to production
counter setting mode.
・ To exit without confirming the setting, press the return key.
The mode will return to production counter editing mode.
S-7300A
key to switch to
, so that the
48