Installing the RAID cage
The optional RAID cage occupies all three of the 5.25-inch drive bays in
the front of the drawer. If you install a RAID cage, you must remove all
5.25-inch devices except the slimline CD-ROM drive.
Power down the system and disconnect the power cables.
1.
Disconnect and remove all drives and cover plates from the 5.25-inch
2.
drive bays.
3.
Configure the RAID cage backplane as described in "SCSI ID address
settings" on page 71 and following.
4.
Align the drive cage rails with the center set of rail guides in the 5.25-
inch drive bays.
Installing the Optional RAID Cage
Slide the RAID cage all of the way into the bay.
5.
6.
Conect the cables to the RAID cage backplane as described in
"Connecting the cables" on page 74.
To Install the RAID Cage
Chapter 3: Components
73