Table of Contents
Advertisement
Remove the two screws that secure the module to the chassis. See the
3.
illustration Replacing a Failed Power Supply Module below.
Replacing a Failed Power Supply Module
4.
Take hold of the handles at the sides of the power supply module and
pull it out of the chassis.
Place the replacement module into the space where the failed module
5.
was and push it firmly into the chassis. Make sure the module is
firmly seated in the connectors at the back of the power supply.
6.
Secure the replacement module with the screws you removed earlier.
7.
Turn on the power from the replacement supply using the power
switch on the front of the supply module.
8.
Perform any necessary software procedures to inform the operating
system that the new power supply module is present.
Chapter 3: Components
65
Advertisement
Table of Contents
Troubleshooting
