Gateway ALR 9250R User Manual page 75

Holding the memory module by its edges, align the module so its edge
2.
engages in the connector on the system board. See the illustration
Installing the Memory Module below.
Installing the Memory Module
Push the memory module toward the system board until it fully
3.
engages its connector.
Replace the top cover and screws.
4.
Caution!
The memory module is held
in place by the 242-pin
connector on the system
board, the guide rail at the
back of the electronics bay,
and a plastic guide at the
front of the electronics bay.
You must support the
module until it is fully
seated in the connector.
Chapter 3: Components 61